Rothenberger Pipeslice 28mm

For 28mm copper, the Rothenberger Pipeslice 28mm gives you a quick one-handed cut in a tight space. It fits over the pipe, sets itself to size, locks on and cuts as you rotate it.

Why use a Rothenberger Pipeslice 28mm

28mm pipe often runs on larger heating systems, mains and plant rooms, and it is usually clipped close to walls or other pipes. A normal cutter needs room all round, but the Pipeslice works in a small gap. It cuts without squashing the tube and avoids the outside burr. That keeps the pipe end ready for a Compression, Push-Fit or soldered fitting.

• Brand: Rothenberger
• For 28mm copper pipe
• Self-adjusting, self-locking, one hand
• Replacement wheels available

Place it at the mark and turn it round the pipe. Let it cut at its own pace. Once through, check the inside edge and remove any burr. Blow or brush out swarf after use, and swap the wheel when cuts get slow. A spare wheel is far cheaper than a new tool. Other sizes and spares are listed in our pipe slice section.

Collecting a 28mm pipe slice in Glasgow

Visit Plumb Parts, 555 South Street, Glasgow G14 0QX. Open Mon-Fri 8am-5pm and Sat-Sun 8am-1pm. Prefer to click? Order online.

Specification

• Brand: Rothenberger
• Range: Pipeslice
• Sizes: 28mm
• Suitable for: Cutting 28mm copper close to walls

Common Questions

Why use a Pipeslice on 28mm pipe?

28mm is often clipped tight to walls or other pipes. The Pipeslice needs very little room round the pipe, where a big adjustable cutter would not turn.

Is the Pipeslice 28mm self-adjusting?

Yes, it sets itself to the pipe and locks on. You just keep turning until the pipe parts.

How do I look after a 28mm Pipeslice?

Brush out swarf after use and keep it dry. Swap the wheel when cuts slow down, rather than forcing it.