SPEEDFIT FLEXIBLE HOSE MONOBLOC x PUSH FIT

A Speedfit Flexible Hose Monobloc x Push Fit screws into the base of a monobloc mixer tap at one end and pushes onto the supply pipe at the other. Each one is 300mm long.

Speedfit flexible hose monobloc x Push Fit sizes

Monobloc taps feed through one hole in the basin or sink, so the tails are threaded into the tap body. Most use M10 or M12 threads, which is why two thread sizes are listed. Check the tap before you buy. The Push Fit end means no olives or Compression nuts under the basin, and the joint can be undone again later. These hoses are for hot and cold water supply, not for central heating.

• 15mm x M10, 300mm
• 15mm x M12, 300mm
• 12mm x M10, 300mm
• Threaded tap end, Push Fit pipe end

Screw the threaded ends into the tap by hand before the tap goes into the basin, as it is much easier than working upwards later. Then mount the tap. Cut the supply pipes square, deburr them and mark the insertion depth. Push each hose fully onto its pipe. Use a pipe insert with plastic pipe. Turn the water on slowly and check every joint.

See more styles in our flexi hoses range.

Monobloc tap tails in Glasgow

Monobloc hoses can be picked up at Plumb Parts, 555 South Street, Glasgow G14 0QX, Mon-Fri 8am-5pm or Sat-Sun 8am-1pm. Ordering online works too.

Specification

• Brand: Speedfit
• Connection: Push Fit pipe end x threaded monobloc tap end
• Sizes: 15mm x M10, 15mm x M12, 12mm x M10, all 300mm
• Suitable for: hot and cold water supplies to taps and appliances, not central heating

Common Questions

Monobloc tap hose: M10 or M12 thread?

It depends on the tap. Most monobloc mixers use M10 or M12 in the tap body, so check the tap instructions or the old tails.

Should the hoses go into the tap before it is fitted?

Yes, screw them into the tap body on the bench first. It is far easier than working upward under a basin.

How tight should the threaded tap end be?

Finger tight and then snug. The threads are small and the tap body is soft, so do not force them.