Climaflex Pipe Insulation 28mm x 13mm x 1mtr

Around a boiler or cylinder, 28mm runs tend to be short, so a 1 metre length of Climaflex pipe insulation 28mm x 13mm is easier to use than a full 2 metres. The foam wall is 13mm.

1m Climaflex pipe insulation for 28mm pipe

Plant cupboards and boiler rooms are full of short pipe sections between pumps, valves and tees. A metre at a time is easier to handle in there and wastes less. It also covers short runs of 28mm cold main as it enters a building.

• Fits 28mm pipe
• 13mm wall
• 1m length
• For hot and cold pipework

Measure between fittings and cut pieces to suit, keeping the ends square. Slit, fit and tape each piece. Do not lag over pump unions, strainers or valve heads that need to be reached. For a tidy job, finish the ends neatly at each fitting, because ragged foam soon gets pulled off. Tape across any join that sits on a bend.

Plant room lagging from our Glasgow counter

The full range of sizes is under pipes, hoses and insulation.

Plumb Parts is found at 555 South Street, Glasgow G14 0QX. Its counter runs Mon-Fri 8am-5pm and Sat-Sun 8am-1pm, and you can order online.

Specification

• Brand: Climaflex
• Material: Closed cell polyethylene foam
• Sizes: 28mm bore, 13mm wall, 1m length
• Suitable for: Heating and water pipework
• Pack quantity: One 1m length
• Standard/approval: Fire class Euroclass E (EN 13501-1)
• Max temperature: 0°C to +100°C

Common Questions

Why use 1m lengths in a boiler room?

Runs between pumps, valves and tees are short, so 1m pieces are easier to handle and waste less.

How do I finish lagging at a fitting?

Cut the end square and tape it neatly. Ragged ends get pulled off.

Can I lag a 28mm cold main with this?

Yes, it helps stop condensation. Tape every seam so damp air cannot reach the pipe.