Pegler XPress Press-Fit Copper Obtuse Elbow 45 Deg 15mm to 88.9mm

The Pegler XPress Press-Fit Copper Obtuse Elbow 45 Deg joins two copper pipes at 45 degrees, with a press joint on each end. It is the everyday fitting for easing a pipe round an obstacle or making an offset without the hard turn of a 90.

What it’s used for

Pairs of 45s are the neat way to step a run sideways past a beam, a duct or another service. They also give better flow than a 90 in pumped heating and in large bore water mains, where pressure drop matters. On plant room work, the bigger sizes help set out headers and connections to equipment.

It is part of the Xpress copper range for hot and cold water, vented and sealed heating and chilled water, but never on gas.

Sizes available

15mm, 22mm, 28mm, 35mm, 42mm, 54mm, 66.7mm, 76.1mm and 88.9mm.

Fitting tips

• Cut copper square, deburr inside and out, and mark the insertion depth on both pipes.
• Set the angle before pressing. Once pressed, it can’t be turned.
• Leak Before Press shows any joint left unpressed when you test.
• For 66.7mm and over, make sure your press tooling covers the size.

For a 45 with a spigot end, see the street elbow in our Xpress copper Press-Fit section.

45 degree elbows in Glasgow

You can grab one at the Plumb Parts trade counter, 555 South Street, Glasgow G14 0QX, or order online. Open Mon-Fri 8am-5pm, Sat-Sun 8am-1pm.

Specification

• Brand: Pegler XPress
• Range: Xpress Copper
• Maker code: S21; article numbers 38410 (15mm), 38412 (22mm), 38414 (28mm), 38416 (35mm), 38417 (42mm), 38418 (54mm), 38419 (66.7mm), 38420 (76.1mm), 38422 (88.9mm), 38421 (108mm)
• Connection: Press Fit with EPDM seal both ends, 45 degrees
• Sizes: 15mm, 22mm, 28mm, 35mm, 42mm, 54mm, 66.7mm, 76.1mm and 88.9mm
• Standard or approval: EN 1254-7 press fittings, BSI certificate KM 789225 (water fittings)
• Max pressure: 16 bar
• Suitable for: Hot and cold water, heating and chilled water on hard and half-hard copper tube; not gas
• Max temperature: -20°C to +110°C

Common Questions

Why use two 45s instead of a 90?

A pair of 45 degree bends gives a gentle offset with less pressure drop than a hard right angle. That helps on pumped heating and big water mains.

Is the 88.9mm size Press Fit too?

Yes, the listing runs from 15mm to 88.9mm. Large sizes need suitable jaws or collars.

Can the obtuse elbow go on gas?

No, this is the water and heating version. Use the Xpress Gas obtuse elbow for gas.