Pegler XPress Press-Fit Copper Reduced Elbow 22mm

Pegler XPress Press-Fit Copper Reduced Elbow

This is a reduced elbow for water and heating copper, a 90 degree turn that steps from 22mm down to 15mm in one fitting. It is made in the one size, 22mm x 15mm.

That saves a separate reducer and an extra press in a tight corner, and 22mm to 15mm is the step most used on house heating and water branches. Each end needs its own jaw, 22mm and 15mm, pressed once the tube is fully home.

Browse the whole Pegler XPress Press-Fit Fittings range at Plumb Parts, running from 15mm up to 108mm.

Alongside this one, the Pegler XPress Press-Fit system takes in: Copper Straight Couplers, Copper Reducing Couplers, Copper Straight Coupling Slips, Copper Straight Female Connectors, Copper Straight Male Connectors, Copper Male Reducers, Copper Female Adaptors, Copper Male Adaptors, Copper Union Coupling, Copper Equal Elbows, Copper Reduced Elbows, Copper Street Elbows, Copper Knuckle Elbows, Copper Male Elbows, Copper Female Elbows, Copper Backplate Elbows, Copper Long Pattern BackPlate Elbows, Copper Bends, Copper Obtuse Elbows, Copper Obtuse Street Elbows, Copper Crossover, Copper Partial Crossovers, Copper Full Crossovers, Copper Equal Tees, Copper Reduced Branch tees, Copper One End Reduced Tees, Copper One End Reduced And End Branch reduced Tees, Copper Both End Reduced Tees, Copper Female Branch Tees, Copper Multi Port Female Branch Tees, Copper Stop Ends, Copper Unions, Copper Straight Male Union Connectors, Copper Straight Female Union Connectors.

Xpress copper keeps installation simple. No heat is involved, jointing is rapid, and the same system covers domestic, commercial and industrial pipework.

Why installers choose Xpress

• Rated for use from -20°C to 110°C
• Pressure rating of 16 bar over the full temperature range
• Leak Before Press: any joint that has not been pressed shows up as a leak when the system is tested
• Kitemarked by BSI against BS 8537:2010
• Rapid jointing cuts labour and time compared with the traditional way
• Because there is no heat, no hot works permit or insurance cover is needed
• Holds many UK and international approvals
• Chrome plated fittings in the range suit visible pipe runs

Specification

• Brand: Pegler XPress
• Range: Xpress Copper (water)
• Maker code: 7002R; article numbers 38311 (22mm x 15mm)
• Material: Copper
• Connection: Press Fit ends with EPDM O rings
• Sizes: 22mm x 15mm
• Standard or approval: BS EN 1254-7 (BSI Kitemark KM 789225)
• Max pressure: 16 bar
• Suitable for: Water services on hard and half-hard copper tube
• Max temperature: -20°C to +110°C

Common Questions

Why use a reduced elbow?

It turns 90 degrees and steps from 22mm down to 15mm in one fitting. That saves a reducer and a press in a tight corner.

Is only one size available?

We list the 22mm x 15mm, which is by far the most used on house heating and water branches.

Does each end need its own jaw?

Yes, the 22mm end takes a 22mm jaw and the 15mm end a 15mm jaw. Press both after the tube is fully in.

Plumb Parts, 555 South Street, Glasgow G14 0QX. Collect in store or have it delivered. Open Mon-Fri 8am-5pm, Sat-Sun 8am-1pm.